![]() ![]() Hence why, you remove the battery from the vehicle. The ground connection for a battery charger, used at a 2-4 amp rate (trickle charging) should ALWAYS be applied direct to the ground side post of the battery. Secondly, you do NOT hook a battery charger up to charge a battery by applying an alternate ground source, i.e. I can tell you right now, that you, and the author of the original post don't know what you're talking about. I am a professional, factory Toyota trained technician. which is confusing, not only because it seems to contradict itself (first it advocates never using the negative battery terminal, then at the end it says to use it after all), but also because there's a mess of disagreements in the comments, for example. ![]() Once everything is in place, connect the trickle charger to a power socket. Do not touch the wires while the charger is plugged in and turned on, as serious shock or injury may occur.Ĭonnect the black clip to the negative batter terminal and the red clip to the positive one. It is important to ensure that this negative wire is solidly attached before plugging in your charger. Once you have ensured you have a solid connection, connect the black, negative wire to your ground location located in step 2. Take the red or positive cable and attach it to the positive terminal of the battery to be charged. There should be a black clip and a red clip. Attach CablesĬonnect the alligator clips. The negative terminal on the battery should never be used, as it can cause an explosion or fire. Ideally a spot of bare metal on the frame, or a large bolt attached to the chassis or engine block should be used, but if one cannot be located, a section of the frame that is free of excessive dirt, grime and oil will suffice. Locate a Suitable Ground Locationįinding a suitable location to attach the negative terminal of your charger is the key to safe and effective completion of your trickle charger circuit. I thought this couldn't be simpler: ventilate, unhook the battery, connect the positive first, then the negative, then turn on the power. I'm trickle-charging a car using direct connections to the battery. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |